Proview LCD monitor repair part 3

Yesterday I went to Radio Shack and bought 2 of the 470uf capacitors. They didn’t have any of the other ones. As a side note I was told that there were 6 470uf capacitors when on my board there are only 2. The 4 680uf capacitors are the one I think are messed up but I’ll have to order them to find out for sure. I ended up soldering in the 2 470uf capacitors and then put everything back together. When I hooked the monitor back up I got the same white screen as before. So no luck yet.

• Proview LCD monitor repair part 2
  11 March 2008 10:41 AM | No Comments

  I took the monitor apart today and pulled the power supply board out. I read that if any of the capacitors were bad that the tops would be bulging but I didn’t see any like that. They all looked good to me so now I...

  Read More
• Proview LCD monitor repair part 5 (a failed mission)
  15 March 2008 11:16 AM | No Comments

  Bad news as far my luck goes on this repair. I changed out one 220uf capacitors. I could only change one because that’s how many my local Radio Shack had left. I did get enough 10uf capacitors to replace the old ones on the video...

  Read More
• Proview LCD monitor repair part 1
  09 March 2008 1:17 AM | 2 Comments

  My Proview LCD monitor is stuck with a white screen but the computer is still working. I’ve had some problems with Proview before. My first Proview LCD lasted less than a year. The one I have now was a replacement for the first one. I’ve...

  Read More
• Proview LCD monitor repair part 4
  12 March 2008 9:23 AM | 1 Comment

  I pulled the monitor apart again today. This time I pulled both power supply board and the video board. I looked for dry solder and sure enough I found some. The video board looked like it had alot of dry solder. I desoldered all the...

  Read More
• Morley PWA wah repair part 3
  13 December 2007 11:50 PM | 2 Comments

  I got the parts to repair the pedal today. After soldering them onto the board I hooked everything up but get no wah. There is one more capacitor that I think needs to be replaced but it will have to wait. I need to think...

  Read More